A solvent borne clear concrete floor seal having good resistance to alkaline substrates. It resists staining and reduces dust levels and in doing so makes cleaning much easier.
Suitable for use on concrete, brick and stone substrates in both internal and external applications.
Outstanding resistance to alkali
Reduces Dust levels
For areas that may become wet or are subject to liquid spills that could result in a potential slipping hazard, we recommend the addition of anti-slip aggregate to the product.
Coverage: 14m² per litre Coverage rate can be affected by such variables as type and condition of substrate, type of application equipment, film thickness applied and individual method of application.
Not suitable for use on power floated floors and self levelling compounds.
Compliance: Complies with “the VOC in Paints, Varnishes & Vehicle Refinishing Products Regulations 2005". EU limit value for this product when used as a binding primer (cat A/h): 750g / litre (2010) and when applied as a floor seal (cat A/i): 500g / litre (2010)
For more information please also see the Flooring products selection guide located in the download tab.
Please refer to Material Safety Data Sheet and Technical Information Sheet prior to the use of this product. See download tab.
Application Methods: Apply product by brush or roller using a long pile, double arm roller. Can also be applied using a squeegee.
Colour Availability: Clear
Pack Size: 5 litres
Drying Time @ 20ºC: Drying times will be extended at low temperatures . Do not apply when ambient temperature falls below 5ºC or relative humidity exceeds 90%.
Surface dry @ 20ºC : 2 hours
Hard Dry@ 20ºC: 4 hours.
Over Coat@ 20ºC: After 24 hours
Flash Point: 38ºC
VOC Content (as supplied): Max 470g / litre
Storage: Store in temperature range 5-40ºC
Thinners: Firwood 114 Thinners
Surface Preparation: Refer to Technical Data Sheet
Mix thoroughly before use with a wide bladed stirrer. A wooden batten at least 25mm wide is ideal.
Directions for Use: Best results are obtained in warm (minimum 15°C), dry conditions with a good through draught.
a brush and/or long pile, double arm roller.
On bare concrete floors: It is recommended that the first coat be diluted with approx. 10-20% Firwood 114 Low odour thinners by volume prior to application. This will act as a binding primer and help seal the concrete surface. Once dried, a second coat can be applied at full strength.
On previously painted floors: It is recommended that two thin coats be applied rather than one thick coat. This will prolong the life and performance of the coating.
Keep coated areas dry for a minimum of 24 hours following application
Foot traffic can be allowed on the coated area after 24 hours and heavier traffic after 72 hours.
Clean application equipment immediately after use with Firwood 114 Thinners
Laitance on concrete - The surface of concrete can have laitance which will flake off with wear. We recommend the use of Firwood 2709 Concrete Etching Fluid to remove surface laitance prior to the use of this floor seal.
Please click here to download the Technical Information Sheet PDF.
Please click here to download the Material Safety Data Sheet PDF.
Please click here to download the Flooring products selection guide PDF.
Used in our wedding venue
By N R E Willcocks from Suffolk on October 13rd 2019
Just ordered another batch having fist used it about 6 years ago to seal the power-floated concrete floor in our wedding barn. After a lot of use, spills and cleaning, it is only just now needing a further coat. Gives a great unobtrusive finish.