A high solids premium quality undercoat for use under decorative paints. Formulated with low odour properties. Suitable for internal and external use. Product exhibits good durability on external applications. Suitable for use as an intermediate coat in decorative paint systems. Provides good obliteration and a smooth finish prior to application of top coats. Suitable for use on wood, ferrous metals and suitably prepared non-ferrous metals.
Provides good obliteration
premium quality undercoat
Suitable for internal and external use
Coverage: Approximately 15m² per 1 litre @ 40 μ DFT. Coverage can be affected by such variables as type and condition of substrate, type of application equipment and individual method of application.
Typical Applications:
Building maintenance
Architectural ironmongery
Internal & external decorating
Compliance: Complies with “the VOC in Paints, Varnishes & Vehicle Refinishing Products Regulations 2005". EU limit value for this product (cat A/d): 300g / litre (2010)
Please refer to Material Safety Data Sheet and Technical Information Sheet prior to the use of this product. See download tab.
Colour Availability: White, Off White, Old Gold, Yellow, Deep Pink, Silver Grey, Pale Lilac
Pack Size: 2. 5 litres
Drying Time @ 20ºC: Drying times will be extended at low temperatures . Do not apply when ambient temperature falls below 5ºC or relative humidity exceeds 90%.
Surface dry @ 20ºC : 1 hour
Hard Dry@ 20ºC: 6 hours
Over Coat@ 20ºC: After 16 hours
Dry Film Thickness: 30 - 50 μ
Wet Film Thickness: 50 -80 μ
Coverage: Approximately 15m² per 1 litre @ 40 μ DFT. Coverage can be affected by such variables as type and condition of substrate, type of application equipment and individual method of application.
Flash Point: 38ºC
VOC Content (as supplied): Max 299g / litre
Storage: Store in temperature range 5-40ºC
Thinners: Firwood 114 Thinners
Directions for Use: All surfaces should be clean, dry and free from grease, rust, millscale, etc.
Mix thoroughly before use using a wide bladed stirrer.If required, surfaces should be prepared with a suitable primer.
For ferrous metals use Firwood 18 High build zinc phosphate primer and for non-ferrous metals use Firwood 90 Rapid dry chromate free etch primer.
Allow a minimum of 16 hours between each coat.
Cleaning: Clean application equipment immediately after use with Firwood 114 Thinners
Please click here to download the Technical Information Sheet PDF.
Please click here to download the Material Safety Data Sheet PDF.