A fast drying acrylic wall paint for application by brush roller or airless spray. This masonry paint has good obliterating powers and its high film build permits single coat application even on vertical surfaces.
Suitable for use on brickwork, rendered walls, breeze block and concrete. Surface to be painted should be dry and free from dust and other contaminants. Always allow recently rendered walls to fully cure before painting.
Easy to apply by brush or roller
Water borne product
Suitable for internal and external applications
High opacity coating with excellent scrub resistance
Coverage: Approximately 4m² per 1 litre @ 250 micronsDFT. Coverage can be affected by such variables as type and condition of substrate, type of application equipment and individual method of application.
Typical Applications:
External walls
Brickwork
Public buildings
Railway stations
Compliance: Complies with “the VOC in Paints, Varnishes & Vehicle Refinishing Products Regulations 2005".
EU limit value for this product (catA/a): 30g / litre (2010)
Application Methods: Airless spray, Brush, Roller
Colour Availability: White. Other shades to order
Pack Size: 5 litre tins
Drying Time @ 20ºC: Drying times will be extended at low temperatures . Do not apply when ambient temperature falls below 10ºC or relative humidity exceeds 85%.
Surface dry @ 20ºC : 30 minutes
Over Coat@ 20ºC: After 24 hours
Coverage: Approximately 4m² per 1 litre @ 250 micronsDFT. Coverage can be affected by such variables as type and condition of substrate, type of application equipment and individual method of application.
Flash Point: Not applicable
VOC Content (as supplied): Max 30g / litre when mixed
Storage: Store in temperature range 5-40ºC
Thinners: Use clean cold water
Surface preparation: Refer to the technical Data Sheet.
Mixing: Mix thoroughly before use using a wide bladed stirrer. A wooden batten at least 25mm
wide is ideal.
Directions for Use: Best results are obtained in warm (minimum 15°C), dry conditions with a good through draught.
Mark or mask off the area to be painted.
Apply 1 or 2 coats as
required at full strength.
Do not dilute.
Cleaning: Application equipment should be
washed immediately after use in clean cold water.
Please click here to download the Technical Information Sheet PDF.
Please click here to download the Material Safety Data Sheet PDF.
Product Reviews
One coat wall paint
By Steve McKeown from Tottington Lancashire on April 15th 2015
Easy to apply and maintain very durable marks clean off very easily