A fast air drying high solids gloss finish with excellent build properties. Produced with a reduced solvent content and high coverage rates. An ideal solution as a compliant coating for manufacturing operations where fast drying schedules are essential.
Suitable for use as a decorative and protective finish in a full painting sequence on ferrous metals, timber and other surfaces. Ideal for both internal and external use and has achieved widespread acceptance as a good all round maintenance finish for brush application.
Internal and external use
Easy application properties
Coverage:Approximately 22.5m² per 1 litre @ 25 μ DFT. Coverage can be affected by such variables as type and condition of substrate, type of application equipment and individual method of application
Mechanical Handling Equipment
Plant & Machinery
Colours in this range are produced upon receipt of order and are not accepted for return unless faulty. Where accurate colour matching is required please request a shade card as online colour charts are not always represented accurately.
Please refer to Material Safety Data Sheet and Technical Information Sheet prior to the use of this product. See download tab.
Application Methods: Conventional Spray, Airless Spray, Hot Spray, Brush
Colour Availability: Full range of BS 4800, BS 381C & RAL shades except fluorescents and metallics
Pack Size: 5 litres
Drying Time @ 20ºC: Drying times will be extended at low temperatures . Do not apply when ambient temperature falls below 5ºC or relative humidity exceeds 90%
Surface Dry @ 20ºC : 30 minutes
Hard Dry@ 20ºC: 4 hours
Over Coat@ 20ºC: From 30 mins to 3 hours after application, otherwise leave until after 48 hours
Dry Film Thickness: 25 - 50 μ,
Wet Film Thickness: 35 -70 μ,
Coverage: Approximately 22.5m² per 1 litre @ 25 μ DFT. Coverage can be affected by such variables as type and condition of substrate, type of application equipment and individual method of application
Flash Point: 30ºC
VOC Content (as supplied): Max 410g / litre
Storage: Store in temperature range 5-40ºC
Thinners: Firwood 113 Thinners
Directions for Use: Ensure all surfaces are clean, dry and free from dust, grease, millscale, etc.
Stir well before use.
If required, apply primer such as Firwood 70 Anti-Corrosive Primer and/or undercoat in accordance with our recommendations.
For galvanised or non-ferrous metals, we recommend the use of a suitable etch primer such as Firwood 90 Rapid Dry Chromate Free Etch Primer.
Cleaning: Clean application equipment immediately after use with Firwood 113 Thinners
Please click here to download the Technical Information Sheet PDF.
Please click here to download the Material Safety Data Sheet PDF.