An air drying, high build semi-gloss finish with anti-corrosive pigments for good long term durability. A low voc compliant one coat finish providing good protection and economy in use.
Suitable for use as a one coat primer/finish or as part of a multi-coat sequence on ferrous and correctly prepared non-ferrous metals.
- Contains anti-corrosive pigments
- Good long term durability
Approximately 7.5m² per 1 litre @ 75 μ DFT. Coverage can be affected by such variables as type and condition of substrate, type of application equipment and individual method of application. Typical Applications:
- Structural Steel
Complies with "the VOC in Paints, Varnishes & Vehicle Refinishing Products Regulations 2005". EU limit value for this product (cat A/i): 500g / litre (2010)
Please refer to Material Safety Data Sheet and Technical Information Sheet prior to the use of this product. See download tab.
Application Methods: Airless spray - tip size 0.015-0.017" Pressure 1800-2100 psi Brush (small area only)
Colour Availability: Full range of BS 4800, BS 381C & RAL shades except fluorescents and metallics.
Pack Size: 20 litres
Drying Time @ 20ºC: Drying times will be extended at low temperatures . Do not apply when ambient temperature falls below 5ºC or relative humidity exceeds 90%.
Surface dry @ 20ºC : 20 minutes
Hard Dry@ 20ºC: 4 hours
Dry Film Thickness: 50 - 100 μ
Wet Film Thickness: 95 - 195 μ
Coverage: Approximately 7.5m² per 1 litre @ 75 μ DFT. Coverage can be affected by such variables as type and condition of substrate, type of application equipment and individual method of application.
Flash Point: 28ºC
VOC Content (as supplied): Max 420g / litre when mixed
Storage: Store in temperature range 5-40ºC
Thinners: Firwood 113 Thinners
Directions for Use: Ensure all surfaces are clean, dry and free from dust, grease, millscale, etc.
Stir thoroughly prior to use.
Surfaces should be shot blasted to Sa2½ and coated within 4 hours or mechanically wire brushed to remove loose rust and mill scale..
For galvanised or non-ferrous metals, we recommend the use of a suitable etch primer such as Firwood 90 Rapid Dry Chromate Free Etch Primer.
Cleaning: Clean application equipment immediately after use with Firwood 113 Thinners
Please click here
to download the Technical Information Sheet PDF.
Please click here
to download the Material Safety Data Sheet PDF.