Complies with “the VOC in Paints,Varnishes & Vehicle Refinishing Products Regulations 2005".EU limit value for this product when used as a binding primer
(cat A/h): 750g / litre (2010). When used as a floor paint (cat
A/i): 500 g/l (2010).
Please refer to Material Safety data Sheet and Technical Information Sheet prior to the use of this product. See download tab.
Application Methods: Apply product by brush or roller using a long pile, double arm roller.
Drying Time @ 20ºC: Drying times will be extended at low temperatures . Do not apply when ambient temperature falls below 5ºC or relative humidity exceeds 90%.
Surface dry @ 20ºC : 1 hour
Hard Dry@ 20ºC: 4 hours
Over Coat@ 20ºC: After 24 hours
Coverage: Approximately 12m² per 1 litre. Can be affected by such variables as type and condition of floor and method of application .
Flash Point: 38ºC
VOC Content (as suppled): Max 499g / litre
Storage: Store in temperature range 5-40ºC
Thinners: Firwood 114 Thinners
Surface preparation: Refer to the Technical Data Sheet.
Directions for Use:
Best results are obtained in warm (minimum 15°C), dry conditions with a good through draught.
Apply using a brush and/or long pile, double arm roller.
On bare concrete floors it is recommended that the first coat be diluted with approx. 10-20% Firwood 114 thinners by volume prior to application. This will act as a binding primer and help seal the concrete surface. Once dried, a second coat can be applied at full strength.
On previously painted floors it is recommended that two thin coats be applied rather than one thick coat. This will prolong the life and performance of the coating.
For application onto wooden floors, a minimum of two coats is recommended. Chipboard flooring may require three coats due to absorption of the coating into the substrate. Do not flood pour the coating onto the floor.
Cleaning: Application equipment should be cleaned immediately after use with Firwood 114 low odour thinners.
Please click here to download the Technical Information Sheet PDF.
Please click here to download the Material Safety Data Sheet PDF.