A fast drying, water borne acrylic line marking paint. Quick and easy to apply and produces sharply defined edges. Good resistance to petrol, diesel, oil and water and excellent resistance to tyre pick up.
Suitable for use on both bare and previously painted concrete and asphalt surfaces.
Low odour, Solvent and lead free
Use as full gloss or anti slip - reduce accidents
Suitable for vehicles and fork lifts - hard wearing
Good chemical resistance - anti stain & abrasion
Adheres to concrete, steel and ceramic tiles - Easy to apply
Coverage: Approximately Rate 110 metres per litre on absorbent surfaces @ 50mm line width. Coverage can be affected by such variables as type and condition of substrate, type of application equipment and individual method of application.
Typical Applications:
Car Parks
Factory Floors
Warehouses
Ports & Harbours
Compliance:
Complies with “the VOC in Paints, Varnishes & Vehicle Refinishing Products Regulations 2005".
EU limit value for this product (catA/i): 140g / litre (2010)
For more information please also see the Flooring products selection guide located in the download tab.
Please refer to Material Safety Data Sheet and Technical Information Sheet prior to the use of this product. See download tab.
Application Methods: Brush, Roller
Colour Availability: White, Green, Blue, Black & Yellow.
Pack Size: 5 litres
Drying Time @ 20ºC: Drying times will be extended at low temperatures . Do not apply when ambient temperature falls below 10ºC or relative humidity exceeds 85%.
Surface dry @ 20ºC : 30 minutes
Hard Dry @ 20ºC: 1 hour
Over Coat @ 20ºC: After 24 hours
Stoving Schedule 20 minutes @ 200 - 220ºC
Coverage: Approximately Rate 110 metres per litre on absorbent surfaces @ 50mm line width. Coverage can be affected by such variables as type and condition of substrate, type of application equipment and individual method of application.
Flash Point: Not applicable
VOC Content (as supplied): Max 70g / litre when mixed
Storage: Store in temperature range 5-40ºC
Thinners: Use clean cold water
Directions for Use: Ensure area to be coated is clean dry and sound. Do not apply to newly laid concrete. On previously unpainted concrete check for laitance and remove prior to coating with line marking paint. We recommend the use of Firwood 2709 Concrete Etching Fluid for this.
Mask off area to be coated or use
a template to get a straight edge. Mix product well before use. Apply
by brush or mini roller. Remove masking tape immediately after
application.
Cleaning: Clean application equipment with
tap water immediately after use and before the coating has dried.
Please click here to download the Technical Information Sheet PDF.
Please click here to download the Material Safety Data Sheet PDF.
Please click here to download the Flooring products selection guide PDF.